Click here to book mark this page.

Primal Pictures

I took a bunch of pics on the newly released Kingman Primal. I had the privaledge of seeing a prototype while I was visiting the LA area and decided to see my sales representative.

Unfortunately, my one camera card had not worked very well and only found out when I got to work to upload them through a fast connection. So, I will post what I was able to salvage. Later, I will get the other pics and post them.

(above) The outside of the box. (below) The inside contents of the box.

(above) The left side. (below) The right side.

Here is a close up of the trigger adjustments. No need to remove the frame from the body for adjusting the front slack.

Just a close up of the rear portion of the marker. Small detail of the bolt cap as compared to an EM1 that has no milling.

A close up of the feed neck clamp. Insert the hopper and twist the screw.

Here is a pic of inside the breech with the barrel removed. The Primal has dual ball detents. That is the larger obsticle on the side. You may see a small hole just below... this is the eye. The Primal is a breakbeam setup. The bolt is also seen. Delrin and with a blasted venturi.

Kinda of a close up of both gauges. The bottom one is for the regulator. the one on the side of the body tells you the LPR's psi. The psi is adjusted by the set screw on the front.

Close up of the trigger frame when on. It is in semi and the eye is turned on. There is a trigger switch onthe back of the grip that can let you turn off the eye. In the upper left corner of the panel (looking at the picture), there is a light causing the eye symbol to glow.

Close up of the trigger panel with the eye turned off. The eye symbol is off.

The last picture for right now. This is the frame set at 13bps in Burst3 mode.

Here is a pic of the heal of the grip. The item to the left is an 'On/Off' toggle switch for turning on and off the eye. The middle item is the charger port (Primal comes with a wall charger). The right most item is a button that is used to change the parameters of the marker.

Here is the innards of the frame. Notice the battery is inside of the frame. The EM1 was inside of a tub that was between the battery and grip frame.

The left side eye cover removed. Notice the eye cover houses the ball detent.

Well, that is about it as far as pics of the Primal. Hope you enjoyed!